Home > News

Be Aware Of This When Using Rollers

Oct. 17, 2018

Matters needing attention:

1. Properly select the appropriate compression ratio of die hole such as Roller Shell for Feed Machine:

2. Adjust the working gap between the ring mold and the roller correctly, preferably between 0.1 and 0.3mm (the "quasi-rotating" state of the roller driven by the ring mold after the startup of the new granulator);

3. New ring mold shall be equipped with new roller for use, and the pressure roller shall be loose before and tight after matching with the ring mold. When there is a sharp Angle on both sides of the roller, it should be promptly grinded down by hand grinder to smooth the flange part of the roller, so as to facilitate good cooperation between the roller and ring mold.

4. Before the feed pelletizing machine, it must undergo preliminary cleaning and magnetic separation treatment to reduce the pressing of iron into mold holes. And should regularly check the mold hole, see whether there is the phenomenon of blocking mold. Rush out or drill out the blocked hole in time;

5. The cone hole of circular mould guide should be plastic changed to form a contraction hole to be repaired. When repairing, it should be noted that the lowest part of the inner surface of circular mould should be higher than 2mm at the bottom of the overpass groove.

6. The roller shell is made of wear-resistant alloy through gold processing and heat treatment. The tooth surface of the roller shell has certain influence on the granulation performance

We are China Pellet Ring Dies Factory. Welcome to out website know more details.

China Pellet Ring Dies Factory


Zhangjiakou Hongxing Machinery Co.,Ltd

Roller Shell & Ring Die custom supplier in the world

Copyright © Zhangjiakou Hongxing Machinery Co., Ltd. All Rights Reserved